CAUTION- Unless the aircraft"s ILS equipment includes reverse sensing capability, when flying inbound on the back course it is necessary to steer the aircraft in the direction opposite the needle deflection when making corrections from off-course to on-course. This "flying away from the needle" is also required when flying outbound on the front course of the localizer. Do not use back course signals for approach unless a back course approach procedure is published for that particular runway and the approach is authorized by ATC. 4. Identification is in International Morse Code and consists of a three-letter identifier preceded by the letter I (DD) transmitted on the localizer frequency. EXAMPLE- I-DIA 5. The localizer provides course guidance throughout the descent path to the runway threshold from a distance of 18 NM from the antenna between an altitude of 1,000 feet above the highest terrain along the course line and 4,500 feet above the elevation of the antenna site. Proper off-course indications are provided throughout the following angular areas of the operational service volume: (a) To 10 degrees either side of the course along a radius of 18 NM from the antenna; and (b) From 10 to 35 degrees either side of the course along a radius of 10 NM. (See FIG 1-1-6.) FIG 1-1-6 Limits of Localizer Coverage RUNWAY 8 NM 0 NM LOCALIZER ANTENNA NORMAL LIMITS OF LOCALIZER COVERAGE: THE SAME AREA APPLIES TO A BACK COURSE WHEN PROVIDED. 6. Unreliable signals may be received outside of these areas. ATC may clear aircraft on procedures beyond the service volume when the controller initiates the action or when the pilot requests, and radar monitoring is provided. 7. The areas described in paragraph 1-1-9 b5 and depicted in FIG 1-1-6 represent a Standard Service Volume (SSV) localizer. All charted procedures with localizer coverage beyond the 18 NM SSV have been through the approval process for Expanded Service Volume (ESV), and have been validated by flight inspection. (See FIG 1-1-7.) 1-1-12 Navigation Aids